Contents
CONTENTS
Contents ............................................................... 2
What is what? ....................................................... 3
Technical data ....................................................... 9
2 - English
CONTENTS
Note the following before
starting:
Please read the operator's manual carefully and make
sure you understand the instructions before using the
machine. These instructions supplement the instructions
that were included with the machine. For other
procedures, please refer to the operating instructions for
the machine.
Husqvarna AB has a policy of continuous product
development and therefore reserves the right to modify
the design and appearance of products without prior
notice.
Long-term exposure to noise can result in permanent
hearing impairment. So always use approved hearing
protection.
!
!
!
IMPORTANT! Never use a cutting attachment without
an approved guard. See the chapter on Technical data.
If an incorrect or faulty guard is fitted this can cause
serious personal injury.
IMPORTANT! The trimmer guard must be replaced with
the accompanying combination guard if a grass blade is
fitted to the machine.
IMPORTANT! Wear boots with steel toe-caps and non-
slip sole if a grass blade is fitted to the machine.
For customer assistance, contact us at our website:
www.husqvarna.com
WARNING! Under no circumstances may
the design of the machine be modified
without the permission of the
manufacturer. Always use genuine
accessories. Non-authorized
modifications and/or accessories can
result in serious personal injury or the
death of the operator or others.
Your warranty may not cover damage or
liability caused by the use of non-
authorized accessories or replacement
parts.
WARNING! This accessory may only be
used together with the intended trimmer,
see under heading "Approved
accessories" in chapter Technical data in
the machine's Operator's Manual.
WARNING! Only grass blades/grass
cutters or trimmer heads/plastic blades
may be used when the J-handle is fitted.
Saw blades must never be used with the
J-handle.