Kongskilde MC 3000 Instructions De Service page 39

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 44
Clearance check
With bed knife retaining screws tightened to the above specification, check knife clea-
rance by cutting and scoring films of known thickness across the full knife length. Optimum
resharpened cutting clearances are dependent upon cutter/granulator model and grinding
procedure:
Model
Grinding procedure
MC 3000F
Pre-ground on spare rotor
MC 3000F
In-cutter
MC 3000FS
In-cutter
If clearances vary from specifications, loosen all three bed knife retaining screws roughly
1/4 turn and re-adjust knife as necessary.
IMPORTANT: Only adjust bed knife with all three retaining screws turn loose.Only check
clearances (and operate cutter) with screws tightened to 40 Nm (29 ft-lb)
*
Pre-ground knives often give a slightly different clearance for each rotor knife: ad
just the bed knife to score 0.025 mm (1-mil) film on the closer rotor knife, leaving
the clearance slightly greater on the other knife.
Film thickness
Cut
Score
0.075 mm
0.013-0.05 mm
(0.003")
(0.0005-0.002")
0.025 mm
0.013 mm
(0.001")
(0.0005")
0.013 mm
0.006 mm
(0.0005")
(0.00025")
39

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mc 5000Kg 3000Kg 5000

Table des Matières