Maintenance Plan; After Each Operation; Storage; Disposal - HOLZMANN MASCHINEN KAM 45PRO Mode D'emploi

14.3 Maintenance plan

After each operation:

 The machine has to be cleaned after each operation Beware for hot machine components.
No cleaning immediately after turning off the machine
 Residues on the feeding rollers can be easy removed as follows: heat glue up to 120°C
(250°F), start feeding motor and let make the roller few turns so the new hot glue heat
the residual material on the roller. Press a wooden scoop carefully to the roller so you
can remove the residual material. For finalized cleaning use a damp cloth with cleaning
benzene.
After 50 work hours
 In order to keep the Hot Melt Adhesive Tank clean, it should be cleaned every 50 hours.
Method: when the remaining hot melt adhesive is intemperate / luke warm, clean up the
leaving adhesive in the bottom of glue pot with a wooden scoop, then add new hot melt
adhesive.

14.4 Storage

Switch off the temperature controller, the storage indicator light will turn on when temperature
reaches below 60°C (140°F). Then store the machine back to original box accordingly.
Keep the machine clean and tidy in a place not reachable for children

14.5 Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
15

TROUBLESHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Machine does not start
Edge is not fully covered
with glue
Edges do not stick together
While gluing the edges go
up or down
No movement on edge
transport
Feeding roller motor does not
start
HOLZMANN MASCHINEN GmbH
Possible cause
 Switch defective
 Power supply is off
 Fuse is defective
 Electric contactor is defective
 The granulate in the glue pot is
not fully melted into liquid
 Glue amount is not adjusted to
the appropriate volume
 Residues into the glue pot
 Incorrect temperature or glue
granule
 Wrong granulate
 Wrong edge height adjustment
 Feeding roller dirty
 Glue not fully dissolved
www.holzmann-maschinen.at
TROUBLESHOOTING
Solution
 Repair switch
 Repair power supply
 Change fuse
 Repair or change electric
contactor
 Increase the heating period
 Increase the glue amount by
glue adjustment knob
 Clean the glue pot
 Set temperature correctly or
check glue granule
 Select right granulate
 Set edge height adjustment
new
 Clean feeding roller
 Increase heating
temperature, switch on
when reached re-set temp.
KAM45PRO
31