Preparation - Pettec FUNK SPRAY TRAINER Manuel De Fonctionnement

ASSEMBLE COLLAR

Preparation

Remove the buckle and clamping lock
from the collar.
Re-integrate clamping lock
Thread the clamping lock back onto
the textile band.
Adjust length of collar
Continue pulling textile band until desired
collar length is achieved. Then feed the
leftover band back down through the
remaining slit in the buckle.
Integrate trainer
Thread the textile band through the plastic slit
on one side of the trainer, wrap it around the
front of the device and guide it back through
the slit on the other side.
Thread buckle onto band
Thread the textile band through the slit in
the buckle from below as pictured.