Zotac AMP BOX MINI Guide D'installation Rapide page 4

I N S TA L L I N G A D O U B L E - S LOT C A R D
1. Follow the instructions on the previous page to remove the frame bracket and the riser slot.
2. Remove the two screws and brackets from the frame bracket.
3. Install the double-slot card to the frame bracket (taking a two slot Graphics card as an example).
4. Tighten and secure the Graphics card to the bracket with the screws provided.
5. Install the riser card to your double-slot card.
6. Connect one end of the provided 8-pin power cable to the power connector on the motherboard.
(shown below)
Note: This step is only required if the installed add-on card requires an additional 8-pin power connector
to operate.
7. Connect the other end of the 8-pin power cable to the add-on card (up to 150W).
8. Insert the add-on card with frame bracket back into the box and slide the Riser card into the
PCI-e slot.
9. Install the thumb screws to secure it.
10. Reinstall the cover and the rear thumb screws.
2
6
F R O N T PA N E L
1. Power LED
2. USB 3.0 ports
1
2
3
4
7
5
8
R E A R PA N E L
1. Thunderbolt 3 port
2. Power input (DC19V)
3. Power switch
1
2
10
9
3
3