EUROMAC EUROM GOLDEN 2000 AMBER SMART Mode D'emploi page 18

directly away from the heater. It may not become hot!
 Adjust the desire radiation angle of the device. Do this by undoing both Allen screws
slightly using the Allen key. Make sure you secure them again once you have made the
adjustments! The heater can rotate through approximately 90° - with wall fastening
from 30° upwards to approximately 60° downwards. When adjusting the angle ensure
that the radiator does not radiate heat onto flammable materials from a short
distance!
 Fasten all screws another time firmly and scheck or the heater is firmly mounted. Now
your infra red heater is ready for use.
 For personal protection the installation, to which the EUROM GOLDEN 2000 AMBER
SMART is connected, has to be equipped with an earth fall device (max. 30 mAmp).
Under some circumstances it may be attractive to make a fast connection between the
heater and the main supply, and to operate the heater with a switch. Because the
EUROM GOLDEN 2000 AMBER SMART has a high water tightness (IP65) and for safety
reasons, such a connection has to be made by a qualified electrician.
WORKING
Check for every use:
- or the appliance doesn't show signs of damage.
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating duet o
wind or rain could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (220-240V-50Hz) and is
grounded.
If everything is all right you can insert the plug into the socket.
The Golden 2000 Amber Smart has a remote control that works with two batteries: AAA,
1.5V.
While using, point the remote control to the receiving point of the heater. If there are
obstacles between remote control and the heater, it will not work!
 Press the on/off switch (5) on the side of the unit to "I" (on); The red light on the
reception point will go on.
 Set the device into operation by pressing the ON
button of the remote control. The device has a
'slow start' at 33% output (NB. This requires a fuse
type C). 4 seconds after starting, it automatically
switches to the most recently used output. On first
use, it will switch to 100% output after 4 seconds.
 With the Ʌ-arrow, you can switch to a higher
heating level
 With the V-arrow, you can switch to a lower heating
level
 Pressing on the MAX button takes you straight to
the highest heating level.
 To stop the unit, first press the 'off' button on the remote control. Then turn it off by
pressing the on/off-switch (5) to 'O' (off). Finally, unplug it from the wall outlet. Allow
the heater to cool down.
18