Cleaning; Maintenance; Replacing The Filter; Storage - Parkside PHSSA 20-Li B1 Traduction Des Instructions D'origine

(4) and removing the collection con-
tainer (1).
2. Carefully remove the filter (3) and filter
holder (2) from the collection container
(1).
3. Empty the collection container (1).
4. Clean the collection container (1) with
a damp cloth if required. If required,
clean the filter (3) as indicated in the
"Cleaning" section.
5. Place the filter holder (2) and filter (3)
back into the collection container (1).
Due to its shape, the filter holder (2)
can only be inserted into the collection
container (1) in one position.
6. Re-attach the collection container (1)
onto the device. Place it on the under-
side of the device and allow it to latch
into the interlock release on the top
side of the device.

Cleaning

Always remove the recharge-
able battery before carrying
out work on the device.
Risk of injury!
Never spray down the device
with water or place it in wa-
ter! Do not use any abrasive
cleaning agents or solvents.
The device could become
damaged.
• Clean the housing with a dry cloth or
paint brush.
• Tap the filter (3) and clean it with a
brush or compressed air.
You can also clean a heavily soiled
lamella fine filter under running water.
�� Allow it to fully dry before using it
again.
If the filter is contaminated and cannot
be cleaned, replace it!
See "Spare parts/Accessories".
• Empty the collection container (1) after
every use.
Clean the collection container (1) with
a damp cloth.
• Always keep the ventilation slit on the
device housing unobstructed otherwise
the device will overheat.

Maintenance

Replacing the filter

If contaminated, replace the filter with a
new one.
New filters can be acquired from the
online shop. See "Replacement parts/Ac-
cessories".
1. Remove the collection container (1) by
pressing the release button (4) and de-
tachingn the collection container (1).
2. Remove the filter (3) from the filter
holder (2).
3. Place the new filter into the filter holder.
Ensure the filter is positioned correctly
and securely.
4. Re-attach the collection container (1)
onto the device by placing it on the
underside of the device and allowing it
to latch into the interlock release on the
top side of the device.

Storage

• Store the device in a dry place, out of
reach of children.
• The storage temperature for the battery
and the device is between 0 °C and
45 °C. Avoid extreme cold or heat dur-
ing storage to ensure the battery output
is not adversely affected.
GB IE
21