Technical Specifications; Receiver; Handset - vse Weber Hydraulik Notice D'utilisation

To optimize the range of the handset, it is recommended that the receiver
be installed on the driver's side, preferably against the side of the vehicle.
The receiver must be connected to the VSE system box by means of the
supplied extension cable (15 meters). We can also supply you with an
extension cable of a different length, if desired.

Technical specifications

Receiver

Supply voltage
Fuse
IP classification
Note: If the system is not working properly, first check the fuse in
the receiver.

Handset

Range
Operating frequency
IP classification
Battery
Battery replacement indication
Battery life
Impact-resistant
VSE service line: +31 (0) 318 545745
www.v-s-e.nl/service
Gebruikershandleiding
User Manual
Benutzeranleitung
Notice d'utilisation Documentnr.
24 Vdc
10 A (fast, 5x20mm) glass fuse,
on circuit board.
IP68 (completely waterproof)
Up to 350 m
868 MHz
IP65 splash-proof
9V 600mAh (1 pc.)
LED lamp on handset flashes
slowly during operation = new
battery required
2 years (100 hours of continuous
use)
Up to 2 meters
Pagina 17
A10477.0.01.B
VSE takes you further!
VSE takes you further!