Programming The Receiver For A New Or Additional Handset; Replacing The Battery In The Handset; Installing The Receiver - vse Weber Hydraulik Notice D'utilisation

takes further! takes takes you takes further! VSE takes you further! takes further!VSE you you you further!VSE further!VSE you VSE VSE
Programming the receiver for a new or additional Programming the receiver for a new or additional Programming the receiver for a new or additional
handset
In case of programming a new or additional handset please follow the In case of programming a new or additional handset please In case of programming a new or additional handset please
instructions below:
1. Make sure the receiver i Make sure the receiver is
connected correctly. connected correctly.
2. Press the programming Press the programming
button on the bottom of
the receiver for 1 second the receiver for 1 second
3. The status LED on t
receiver will light red
4. Press the stop button o Press the stop button on
the handset
5. The status LED on t
receiver will start to
yellow
6. The handset is now The handset is now
programmed for the
receiver
7. Repeat the upper instructions i Repeat the upper instructions in case of programming another
handset
8. To erase all handsets out of the memory of the receive, press th To erase all handsets out of the memory of the receive, press th To erase all handsets out of the memory of the receive, press the
programming button more than 8 seconds until the red status LED
on the receiver turns off. on the receiver turns off

Replacing the battery in the handset

Replacing the battery in the handset
The handset has a battery The handset has a battery
replacement indicator. When the LED replacement indicator. When the LED
on the handset flashes slowly while a on the handset flashes slowly while a
function is activated this means function is activated this means that
the battery is nearly discharged and the battery is nearly discharged and
is due for replacement.
The battery is located in the handset. The battery is located in the handset.
To replace it, the back cover of the To replace it, the back cover of the
handset must be opened by handset must be opened by
removing the four screws. Then removing the four screws. Then
replace the battery (9V 600mAh) and replace the battery (9V 600mAh) and
reinstall the back cover.

Installing the receiver

Installing the receiver
n the bottom of
on the
red
on the
start to flash
rogrammed for the
button more than 8 seconds until the red status LED button more than 8 seconds until the red status LED
ver.
Gebruikershandleiding
User Manual
Benutzeranleitung
Notice d'utilisation Documentnr. Notice d'utilisation Documentnr.
Programming Programming
button button
n case of programming another
Pagina 16
A10477.0.01.B