Manual Steering; Switching Off Manual Control - vse Weber Hydraulik Notice D'utilisation

Manual steering

When manual control is switched on, the 'L' and 'R' buttons on the
handset can be used to steer the axle(s) through a left or right bend. The
buttons may only be operated one at a time. If both buttons are pressed
at the same time, the steering system will not respond.
For a steering system with two ETS steered axles, both axles will initially
be turned with the same steering angle, as for the normal steering mode.
The moment the last axle reaches its maximum steering angle it will stop.
The second-to-last axle will then continue to turn until it too has reached
its maximum steering angle (parallel steering).
For a steering system with three ETS steered axles, the steered axles will
be turned with the same steering angle as for the normal steering mode.
Centering
When the centering button is pressed during manual operation, the ETS
axles will be steered to the straight-ahead position.
The two LEDs at the top of the handset will be lit continuously.
Pressing the centering button again will cancel the centering function, and
the 'L' and 'R' buttons can then be used again to steer through a left or
right bend respectively.
The two LEDs at the top of the handset will begin flashing again.

Switching off manual control

When the 'OFF' button on the handset is pressed briefly, the controller
switches to normal control mode.
The ETS function lamp on the trailer goes out.
The LEDs at the top of the manual control receiver go out.
When the manual operating mode is active and the vehicle speed exceeds
12 km/h, the steering system automatically switches to normal operating
mode.
If the vehicle speed does not exceed 25 km/h, the manual operating mode
will become active again when the vehicle speed drops below 12 km/h.
The ETS function lamp on the trailer will continue to flash quickly.
If the vehicle speed exceeds 25 km/h with the manual control mode still
active, a 'silent' manual control alarm will be generated. During this
alarm, the steering continues to function normally.
The ETS function lamp on the trailer will begin flashing slowly:
short on (1 second) and long off (2 seconds).
To reset this alarm, manual control must be switched off by briefly
pressing the 'OFF' button on the handset.
Gebruikershandleiding
User Manual
Benutzeranleitung
Notice d'utilisation Documentnr.
Pagina 14
A10477.0.01.B
VSE takes you further!
VSE takes you further!