APPLIANCE CLEANING
ATTENTION: Make sure the appliance is off and unplugged before disassembling it.
- Use only a clean and soft cloth only for cleaning the appliance body (D).
- All components may be cleaned using warm water and any kind of dish detergent. For cleaning
the valve (A), lift the edge and remove it (Fig. 9).
- Wash the container (M) with dish detergent and a sponge, and then rinse.
ATTENTION:
In order to make components cleaning easier, after use, let them immersed in warm water with
a little dish detergent for 10 minutes.
In case of deformation of the container or the non-stick coating is damaged, replace it with a
new one bought at the nearest dealer. Do not use pans or other similar products.
Do not clean the container using abrasive powder, steel wool, or nylon. Clean the pan using
a sponge. Do not slam or scrape it.
ERROR LIST
Error
Cause
E0
it is shown in case of container removal
E1
lower sensor circuit faulty
The lower sensor detects the temperatu-
re below -15°C.
E2
upper sensor circuit faulty
The upper sensor detects the temperatu-
re below -15°C.
E3
lower sensor short circuit
The lower sensor detects the temperatu-
re above 190°C.
E4
upper sensor short circuit
The upper sensor detects the temperatu-
re above 190°C.
Actions
insert the container into the appliance
properly
immediately switch the appliance off
and leave it to cool. If the problem
remains and the error icon does not
disappear, a heating circuit failure may
have occurred; therefore contact the
Service Centre.
- 15 -
EN