Switching Off; Charging Procedure - Vyaire MicroLab Manuel D'utilisation

Switching Off

The unit is switched off by pressing the On/Off button.
The unit can be disconnected from the mains by unplugging the
charger from the mains socket or unplugging the USB cable if no
mains supply is connected.

Charging Procedure

The MicroLab's internal batteries should be fully charged on first
use. It is also necessary that if the MicroLab is not in use, then it
must be recharged continuously to keep the battery alive. A fully
charged device will hold the charge for a few months. Plug the
AC adapter into the mains supply and plug the adapter output
plug into the power input socket on the right hand side of the
instrument. The orange charging light next to the power input
socket will flash to indicate charging and will turn on constantly to
indicate full charge.
The batteries will take approximately 4 hours to become fully
charged.
Note: Use only the AC adapter supplied. Use of any other type
may cause permanent damage to the MicroLab and cause a fire or
electrical hazard. Do not plug in and remove the power lead from
the AC adapter repeatedly.
Please Note: Dispose of the waste battery in accordance with EU
Waste Battery Regulations.
79