Ryobi CSD41 Manuel D'utilisation page 5

GB
FR DE ES IT
GENERAL SAFETY RULES
CLASS 1 LED PRODUCT
SPECIAL SAFETY RULES
Hold po wer tool b y insulated gripping surfaces,
■
when performing an operation where the fastener
may contact hid den wiring. Cutting accessory
contacting a «live» wire may mak e e xposed metal
parts of the power tool «live» and could give the
operator an electric shock.
CHARGER SAFETY
Do not expose charger to wet or damp conditions.
■
Use of an attachment not recommended or sold by
■
the batter y charger manufacturer may result in a risk
of fire, electric shock, or injuries to person.
To reduce risk of damage to charger body and
■
cord, p ull b y charger plug rather than cord when
disconnecting charger.
Make sure cord is located so that it will not be stepped
■
on, tr ipped o ver, or otherwise subjected to damage
and stress.
An e xtension cord should not be used unless
■
absolutely necessar y. Use of improper extension
cord could result in a risk of fire and electric shoc k.
If extension cord must be used, make sure:
a. That pins on plug of extension cord are the same
number, size and shape as those of plug on charger.
b. That e xtension cord is properly wired and in good
electrical condition.
Do not operate charger with a damaged cord or
■
plug. If damaged, have it replaced immediately by a
qualified serviceman.
Do not operate charger if it has received a sharp
■
blow, been dropped, or otherwise damaged in any
way; take it to a qualified serviceman.
Do not disassemble charger ; tak e it to a qualified
■
serviceman when service or repair is required.
Incorrect reassemb ly ma y result in a risk of electric
shock or fire.
To reduce risk of electr ic shoc k, unplug the charger
■
from outlet before attempting any maintenance or
cleaning. Turning off controls will not reduce this risk.
NL PT DK SE FI NO
English
RU PL CZ HU RO LV
Disconnect charger from power supply when not in use.
■
Risk of electric shock. Do not touch uninsulated portion
■
of output connector or uninsulated battery terminal.
Save these instr uctions. Refer to them frequently and
■
use them to instruct others who ma y use this unit.
If y ou loan someone this unit, loan them these
instructions also.
SPECIFICATIONS
Motor
Switch
No load Speed
Clutch
Torque
Collet
Weight (included battery) 0.47 kg
Charger Rating
Input
Output
Charge Time
DESCRIPTION
1. Quick change chuck
2. LED worklight
3. Direction of rotation selector
(forward/reverse/center lock)
4. Switch Trigger
5. Grip zone
6. Charger
7. Red charge light
8. Input jack
9. Charger plug
10. To decrease torque
11. To increase torque
12. Torque adjustment ring
13. Reverse
14. Forward
15. Collet
16. Bit
OPERATION
WARNING
Do not allow f amiliarity with products to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
1
LT EE HR SI SK GR
4 V DC
Single Speed/Reversible
180 r/min.(RPM)
12 Positions
5 Nm max
6.35 mm
230V-AC ~ 50Hz
4.5V-DC
160 mA
10-12 hours
TR