Intended Use - Bühler technologies TF Notice De Montage

TF, TS, Thermolog
1 Introduction
This quick guide will assist you in starting up the unit. Follow
the safety notices or injury to health or property damage may
occur. Carefully read the original operating instructions in-
cluding information on maintenance and troubleshooting
prior to startup. These are located on the included CD and on-
line at
www.buehler-technologies.com
Please direct any questions to:
Bühler Technologies GmbH
Harkortstraße 29
40880 Ratingen
Germany
Tel.: +49 (0) 21 02 / 49 89-0
Fax: +49 (0) 21 02 / 49 89-20
These operating instructions are a part of the equipment. The
manufacturer reserves the right to change performance-, spe-
cification- or technical data without prior notice. Please keep
these instructions for future reference.

1.1 Intended Use

Temperature sensors can be used to monitor the temperature
of a fluid within a tank.
These operating instructions describe several temperature
switches / sensors types in one, as many descriptions identical
or similar.
Please refer to the type plate to identify your model. In addi-
tion to the job number it also contains the item number and
model designation.
If a model has special features, these are described separately
in the operating instructions.
WARNING
All device models are solely intended for industrial applica-
tions. They are not safety components. The devices must not
be used if failure or malfunction thereof jeopardises the
safety and health of persons.
Use in explosive areas is prohibited.
DANGER
Explosion hazard when used in explosive areas
Use in explosive areas is prohibited.
BX140006 ◦ 11/2019
2 Safety instructions
The equipment must be installed by a professional familiar
with the safety requirements and risks.
Be sure to observe the safety regulations and generally applic-
able rules of technology relevant for the installation site. Pre-
vent malfunctions and avoid personal injuries and property
damage.
The operator of the system must ensure:
• Safety notices and operating instructions are available
and observed,
• The respective national accident prevention regulations
are observed,
• The permissible data and operational conditions are
maintained,
• Safety guards are used and mandatory maintenance is
performed,
• Legal regulations are observed during disposal,
• compliance with national installation regulations.
3 Transport and storage
Only transport the product inside the original packaging or a
suitable alternative.
The equipment must be protected from moisture and heat
when not in use. It must be stored in a covered, dry, dust-free
room at room temperature.
4 Setup and Connection
DANGER
Toxic, corrosive gasses
The sample gas can be harmful to the health if inhaled or on
contact.
a) Ensure harmful gases are discharged safely.
b) Switch off the gas supply before performing mainten-
ance and repairs, and flush the gas lines with air. Secure
the gas supply from accidentally being opened.
c) Protect yourself from toxic / corrosive gasses when per-
forming maintenance. Wear suitable protective equip-
ment.
The temperature switch / sensor come complete and can be
screwed onto the container with the thread. The maximum
torque of the screw-in thread is 25 Nm.
When installing, be sure the sealing face is clean and even.
Only screw the temperature switch / sensor into the fitted
thread. Sealed with an elastic sealing ring. No other sealants
required.
Bühler Technologies GmbH 5