Overview Non Verifiable Weighing Systems (Contacts Of Circuit Board [K1] Not Short-Circuited) - KERN&SOHN KFB-TM Instructions D'utilisation Et D'installation

8.1 Overview non verifiable weighing systems
(contacts of circuit board [K1] not short-circuited)
Menu block Menu item
Main menu Submenu
PO CHK
SET H
SET LO
Weighing with
tolerance range,
PCS H
see chap. 7.7
PCS L
BEEP
P1 REF
A2n0
Zero point
0AUto
settings
0rAGE
0tArE
SPEEd
Zero
P2 COM MODE
Interface
parameter
BAUD
KFB/KFN-TM-BA_IA-e-1220
Available settings / explanation
Upper limit value, input see chap. 7.7
Lower limit value, input see chap. 7.7
Not documented
Not documented
Acoustic signal for weighing with tolerance range
no
switched off
ok Audio sound when load is within tolerance limits
nG Audio sound when load is beyond tolerance limits
Automatic zero point correction (Autozero) by changing the
display, digits selectable (0.5d, 1d, 2d, 4d)
Zero setting range
Load range where the display after switching-on the
balance is set to zero. Selectable 0, 2, 5, 10, 20, 50, 100
%
Zero setting range
Load range where the display is set to zero by pressing
. Selectable 0, 2, 4, 10 , 20* , 50, 100%.
Automatic taring „on / off", taring range adjustable in menu
item „0Auto".
Not documented
Zero point setting
Continuous data output
CONT
One output for stable weighing value
ST1
Continuous data output of stable weighing
STC
values
PR1
Output after pressing
Manual totalizing, see chap. 7.8.
PR2
Press and the weighing value will be
added to the summation memory and issued.
For automatic add-up see chap. 7.9.
AUTO*
This function is used to issue and add individual
weighing values automatically to the summation
memory on unloading of weighing scale.
For remote control commands, see chap. 10.4
ASK
wirel
Not documented
kit 1
Available Baudrate: 600, 1200, 2400, 4800, 9600*
37