Weighing With Tare; Weighing With Tolerance Range - KERN&SOHN KFB-TM Instructions D'utilisation Et D'installation

7.6 Weighing with tare


Deposit weighing vessel. After successful standstill control press the
Zero display and indicator
The weight of the container is now internally saved.

Weigh the material, the net weight will be indicated.

The weight of the weighing container will be displayed as a minus number after
removing the weighing container.

The tare procedure can be repeated as many times as necessary, for example
with initial weighing of several components for a mix (add-on weighing). The limit
is reached when the taring range capacity (see type plate)is full.

To change between gross weight and net weight, press

To delete the tare value, remove load from weighing plate and press

7.7 Weighing with tolerance range

You can set an upper or lower limit when weighing with tolerance range and thus
ensure that the weighed load remains exactly within the set limits.
During tolerance tests such as dosing, portioning and sorting the unit will indicate
exceeded or undershot limits by emitting an optical or acoustic signal.
Audio signal:
The acoustic signal depends on the settings in menu block „BEEP".
Options:
Acoustic signal turned off
• no
An acoustic signal sounds when load is within tolerance
• ok
limits
An acoustic signal sounds when load is beyond tolerance
• ng
limits
26
appear.
NE T
button.
.
.
KFB/KFN-TM-BA_IA-e-1220