Description - Hilti SF 144-A Mode D'emploi

Obligation signs
en Wear eye Wear a hard
protection
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Rated speed Revolutions
under no per minute
load
Drilling
without
hammering

2 Description

2.1 Use of the product as directed
The SF 144-A is a hand-held, cordless drill/driver for driving and removing screws and for drilling in steel, wood and
masonry.
The SFH 144-A is a hand-held, cordless hammer drill/driver for driving and removing screws, for drilling in steel, wood
and masonry and for hammer drilling in lightweight concrete and masonry.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Do not use the battery as a power source for other unspecified appliances.
Modification of the power tool or tampering with its parts is not permissible.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Nationally applicable industrial safety regulations must be observed.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
2
Wear ear
hat protection
Volts
Revolutions
per minute
Location of identification data on the power tool
The type designation can be found on the type identifica-
tion plate and the serial number on the side of the motor
housing. Make a note of this data in your operating in-
structions and always refer to it when making an enquiry
to your Hilti representative or service department.
Wear
protective
Type:
gloves
Serial no.:
Direct
current
Hammer
drilling