Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7. Use the two #8-18 x
/
" screws provided to secure the
1
2
warming drawer frame to the cabinet.
A. Two #8-18 x
CUSTOM DRAWER FRONT INSTALLATION INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Phillips screwdriver
■
Drill and appropriate bits
■
Parts Supplied
#8-18 x
/
" screws (6)
1
■
2
Indicator light lens
■
Parts Needed
Custom drawer front
■
Custom handle (optional)
■
Adhesive recommended for plastic to wood
■
A
/
" screws
1
2
FOR WARMING DRAWERS
Complete Installation
1. Check that all parts are now installed. If there is an extra
part, go back through the steps to see which step was
skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For warming drawer use and cleaning, read the Use
and Care Guide.
5. Push in and turn the control knob to HI, and the light
should illuminate.
If warming drawer(s) does not operate, check
the following:
Household fuse is intact and tight, or circuit breaker
■
has not tripped.
Warming drawer is plugged in, and electrical supply
■
is connected.
If you need Assistance or Service:
Please reference the "Warranty" section of the Use and
Care Guide.
Install Custom Drawer Front Panel
The warming drawer has an interface that will allow a modest
range of panel sizes. The actual panel size should be selected
by the customer and the contractor to suit the desired effect.
It is recommended that a qualified carpenter make and install
the custom drawer front and handle(s) to match surrounding
cabinetry.
1. Install warming drawer unit as instructed by the Installation
Instructions provided with the warming drawer.
2. Create the custom drawer front. Below are the minimum and
maximum dimensions for the custom drawer front. The size
of the custom drawer front for the warming drawer will vary
according to the specific installation. The depth of the panel
will vary in order to have the custom warming drawer flush
with the surrounding cabinets.
Model
A - MAX B - MAX A - MIN
24" (60.9 cm)
23
/
"
3
4
Warming
(60.3 cm)
Drawer
27" (68.6 cm)
26
/
"
3
4
Warming
(67.9 cm)
Drawer
30" (76.2 cm)
29
3
/
"
4
Warming
(75.6 cm)
Drawer
A
⁵⁄₁₆" (7.9 mm) dia. hole for
indicator light lens (provided
in this kit). Locate lens directly
in front of indicator light.
B - MIN
10
/
"
23"
9
5
16
(26.2 cm)
(58.4 cm)
(23.0 cm)
10
/
"
26"
9
5
16
(26.2 cm)
(66.1 cm)
(23.0 cm)
10
5
/
"
29"
9
16
(26.2 cm)
(73.7 cm)
(23.0 cm)
B
/
"
1
16
/
"
1
16
1
/
"
16
7
Publicité
Table des Matières
