Tornado Pac-Vac 6 Aircomfort Mode D'emploi page 8

CHANGING HEPA FILTER ASSEMBLY
To change the HEPA filter:
1. Unplug the unit. Remove the lid, paper bag and cloth bag to expose the HEPA filter.
2. Remove the filter cap on the top of the HEPA filter (Fig. 9)
3. Remove the HEPA filter from the dust compartment
4. Insert a new HEPA filter and replace the filter cap (Fig. 10). Refit the cloth bag, paper bag, and
replace lid.
Note: The HEPA filter can NOT be washed and reused.
Fig. 9
MAINTENANCE
Clean the cloth vacuum bag regularly. After emptying the vacuum bag, turn it inside out and shake as
much dust out of the fabric as possible. Optimum performance is achieved by using a paper filter bag
with the cloth bag.
Clean the vacuum bag and HEPA filter or free any blockage and ensure that adequate airflow is
restored.
Use only approved Tornado paper filter bags.
Check the power cord for damage and replace if damaged.
Always unwind the cord completely.
Ensure the vacuum hose, the extension wand and the vacuuming accessories are not blocked.
Ensure that the electrical outlet and the plug are securely connected. Incorrect connections may
cause sparking and damage to the cable socket.
Have your unit serviced by an authorized repair service center if you suspect any potential problems.
Ensure that the flexible vacuum bag ring provides a proper seal before vacuuming.
Recommended replacement parts:
C352-2500
B352-7800
B352-2400
B352-2401
C352-1400
C352-1500
C352-2800
B352-6800
B352-3200
D113-3400
X9714
Fig. 10
Pac-Vac™ Aircomfort Vacuum Cleaner
Paper Bag (10 pack) 90312
Paper Bag (10 pack) 90314
Motor Exhaust Micro Filter
HEPA Filter
Shake Out Bag 90312
Shake Out Bag 90314
Switch Harness
Strain Relief Complete
Power Harness
Motor
Power Cord
8