Publicité
English
1.
To fix the tool holder to the machine, introduce the shank (1) and tighten 2 screws of fixations (2)
(important, watch that screws have the same strength of tightening). Fix the pipe of arrival of the
cooling liquid to the hole planned for that purpose (3).
3
1
2.
Insert the Kennametal tool KM32 (4) into the support (5) and tighten the tool by means of the
screws (6). Pre-tighten the support (5) on the block (1) with screws (7) then adjust the height
thanks to the screw (8) in the wished position. Once this made regulation, to tighten the screws
of blocking (7).
3.
Adjust the offsets of the
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
LL-30-KM32
2
position.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Validation :06.12.13
8
7
5
Document :
Garant:
LL-30-KM32 Mode
BT
d'emploi 1-
Page : 2 de 4
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
6
4
Publicité
