Rupes LH22N Notice D'emploi Et D'entretien page 10

TOOL IDENTIFICATION PLATE
POSITION AND MEANING OF INFORMATION
1. Type of tool.
2. Nominal working voltage in Volts (V).
3. Working frequency in Hertz (Hz).
4. Absorbed current in Amperes (A). Ensure that the power supply to
which the tool is connected can easily tolerate the indicated
current as a minimum.
5. Absorbed power expressed in Watts (W).
6. Tool code or serial number.
7. Technical data of the tool.
8. Maximum rpm
9. The double square indicates that the tool is doubly insulated and
therefore does not require earthing through the power supply
cable.
10. Read all these instructions before operating this product and
save these instructions.
11. Personal safety devices.
12. At the end of its useful life, the product, pursuant to European
Directive 2002/96/CE
implementation in national law, must not be released into the
environment or thrown away as domestic waste, but must be
disposed of at authorised recycling centres (contact the relevant
local authorities for a list of places where the product may be
disposed of according to the law).Disposing of the product
correctly contributes to protecting human health and
safeguarding the environment. Any illegitimate disposal of the
product will be punishable by law.
(RAEE)+2003/108/CE and
GUARANTEE
All tools manufactured by RUPES Spa are guaranteed for 12 months from the
date of purchase against fabrication and material defects. All tools must be
used only with RUPES original accessories and spare parts: we refuse all
responsibility for damages or accidents caused by non-observance of this rule
which will also cause the termination of the guarantee. The guarantee will no
longer be valid if the instructions contained in this booklet are not followed, if
the tool is used for purposes other than that for which it is intended, if it is
dismantled, interfered with in any way or damaged due to neglect. The
guarantee will be made valid by filling-in the form on the
inside back cover of this instruction booklet. If the tool is found to be
defective or malfunctions, it should be returned carriage free in one piece in its
original packing together with the guarantee certificate to the manufacturer or
to one of the Assistance Centres listed in the appendix to this booklet. The
guarantee does not automatically imply replacement of the tool. RUPES Spa
reserves the right to make any technical or design modification to its products
without prior notice. The manufacturer is not liable for any print errors. This
document voids and replaces previous ones.
CONFORMITY DECLARATION
We declare on our responsability that the hand-held motor operated tool, which is
mentioned in the present operating manual, is in comformity with the Essential Re-
quirements of Safety of the following Directives:
2006/42/CE Machinery
its
2006/95/CE Low Tension
2004/108/CE Electromagnetic Compatibility
The tests have been carried out in accordance with following Standards:
EN 60745-1:2008 Safety of hand-held electric motor operated tools
EN 60745-2-3:2007 Particular requirements for grinders, polishers and
disc sanders
UNI EN ISO 3744:1997 Acoustics. Determination of sound power levels of noise
sources.
UNI EN ISO 11203: 1997 Acoustics. Noise emitted by machinery and equipment.
UNI EN 28662-1: 1993 Hand-held portable power tools. Measurement of vibra
tions at the handle.
UNI EN ISO 5349-1: 2004 Mechanical vibration. Measurement and evaluation of hu
man exposure to hand-transmitted vibration.
Electromagnetic compatibility:
EN 55014-1: 2008 + EN 55014-2: 1998
EN 61000-3-2: 2009 + EN61000-3-3: 2008
Electromagnetic fields:
EN 50366: 2004
S.p.A
IL PRESIDENTE
G. Valentini
11