Assembling The Blade - Olympia G 3120 Mode D'emploi

l Assembling the Blade
Protection
8
Before starting to use the guillotine, assemble
the perspex blade protection to protect the us­
er from the sharp guillotine blade.
1. Remove the device carefully from the
packaging.
2. Remove the screws (8) from the pressing
rail (4).
3. Remove the protective card from the per­
spex blade protection (3).
4. Unlock the guillotine arm (1) by turning the
lock (9) clockwise.
5. Pull the guillotine arm (1) upwards a little.
Install the perspex blade protection (3)
carefully, from the rear, so that the protec­
tion is against the blade.
Note: The handle (2) is provided with a small
projection which must be on the left-hand side
of the perspex blade protection (3). Move the
cover so that the screw holes are in line with
the respective thread.
Attention: Property damage! The per­
spex blade protection (3) could be
damaged. Do not tighten the screws
too tight.
6. Fix the perspex blade protection (3) in
place on the pressing rail (4) with the
screws (8).
l Guillotine
1. Remove the device carefully from the
packaging.
Attention: Risk of injury! The guillotine
8
blade is very sharp! Never reach in
towards or take hold of the guillotine
blade.
2. Before starting to use the device, set it
down on a level, stable working base.
Note: The guillotine arm (1) is locked on the
underside of the cutting unit.
3. Unlock the guillotine arm (1) by turning the
lock (9) clockwise.
4. Use the handle (2) to move the guillotine
arm (1) upwards.
5. Place the material to be cut in the required
position under the pressing rail (4) and
press the pressing rail down.
6. Cut the material by moving the guillotine
arm (1) down using the handle (2).
Attention: Risk of injury! The guillotine
blade is very sharp! Never reach in
towards or take hold of the guillotine
blade.
Note: After completing the cutting task, the
guillotine arm (1) must be locked to the under­
side of the cutting unit.
7. Use the handle (2) to move the guillotine
arm (1) down as far as possible. Lock the
guillotine arm by turning the lock (9) anti­
clockwise.
9
7