Manually Setting The Date/Time - Hama RC 130 Mode D'emploi

• Do not short circuit the batteries/rechargeable
batteries and keep them away from uncoated
metal objects.
4. Getting Started
Open the battery compartment cover (8), remove
the contact breaker and then close the battery
compartment cover (8).
5. Operation
Note – Input
Hold down the p button (2) or the q button (3)
to select the values faster.
5.1. Automatic date/time setting using the
DCF signal
• Once you have inserted the battery, the display
is switched on, an acoustic signal sounds and
the alarm clock automatically starts searching
for a DCF signal. During the search, the wireless
symbol will ash. This process can take 3
to 5 minutes.
• When the wireless signal is received, the date and
time are automatically set.
Display
Display ashing
Display steady
(not ashing)
Not displayed
Searching for the DCF
signal
Active
Successful – signal is being
received
Error – signal search ended
Weak signal reception
Note
The clock automatically searches for the DCF signal
once an hour to ensure that the time is correct. If
the search fails, it ends and is repeated at the next
clock hour. The radio icon will go out
• If the station still does not receive a signal, press
and hold the °C/°F button (5) for approx. 3
seconds to start the manual search for the DCF
signal. The wireless symbol
Not
The manual search takes about 3 to 5 minutes. If
the search fails, it ends and is repeated at the next
clock hour. The radio icon will go out.
Note – Summer time
The clock automatically switches to summer time.
appears on the display as long as summer
S
time is activated.

5.2. Manually setting the date/time

• Press and hold the mode button (4) for approx. 3
seconds to start manually setting the date/time.
• Set the following information in the order listed:
hour, minute, year, month, day
• To select the individual values, press the p button
(2) or the q button (3) and con rm each selection
by pressing the mode button (4).
• If you do not make an entry for 30 seconds, the
settings will automatically close.
5.3. Setting the time format and day of the
week
• Press the p button (2) to switch between the 12
and 24-hour formats. In the 12-hour format, AM
or PM appears before the time.
will start to ash
3