SOLAC HU1059 Mode D'emploi page 9

to turn off the humidifier and refill the tank with
water before turning the device back on.
9 When you want to stop the appliance from
•
emitting steam, press 2 or 3 seconds the on/
off selector (1) till the pilot light goes off.
10 Unplug the humidifier from the mains soc-
•
ket and empty the water tank and interior tank
CLEANING
Disconnect the appliance from the mains and
•
allow it to cool before undertaking any cleaning
task.
Clean the electrical equipment and the mains
•
connection with a damp cloth and dry. DO
NOT IMMERSE IN WATER OR ANY OTHER
LIQUID.
Clean the equipment with a damp cloth with a
•
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an acid
•
or base pH such as bleach, or abrasive pro-
ducts, for cleaning the appliance.
Never submerge the appliance in water or any
•
other liquid or place it under running water.
Never submerge the connector in water or any
•
other liquid or place it under running water.
If the appliance is not in good condition of clean-
•
liness, its surface may degrade and inexorably
affect the duration of the appliance's useful life
and could become unsafe to use.
Then dry all parts before its assembly and sto-
•
rage.
There may be some scale deposits in the trans-
•
ducer, particularly in areas with hard water.
- Overcome this drawback by cleaning the
transducer
- Rub down with a dry cloth and remove
remains of moisture.
- Do not place the transducer directly under
the tap.
- Do not rub the transducer with hard or
metal objects.
- Do not clean with chemical products
HOW TO DEAL WITH LIME SCALE INCRUS-
TATIONS:
For the appliance to work correctly it should be
•
kept free of limescale or magnesium incrusta-
tions caused by the use of hard water.
To prevent this kind of problem, we recom-
•
mend the use of water with low lime or magne-
sium mineralisation.
However, if it is not possible to use the kind of
•
water recommended above, you should perio-
dically remove the limescale from the applian-
ce:
- Every 6 weeks if the water is "very hard".
- Every 12 weeks if the water is "hard".
A specific anti-lime scale product should be
•
used on this kind of product.
Fill the tank with water plus the anti-lime pro-
•
duct, leave about 30 minutes, drain and clean
with water.
Homemade solutions are not recommended in
•
the decaling of this appliance, such as the use
of vinegar.
RECOMMENDATIONS
Never leave water in the base or in the tank.
•
Note: Water accumulated over long periods
•
may create bacteria and mildew (fungus).
Dry all the parts inside the appliance carefully,
•
paying particular attention to the transducer.
Store the appliance in a cool, dry place.
•
ANOMALIES AND REPAIR
Take the appliance to an authorised technical
•
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
FOR EU PRODUCT VERSIONS AND/OR IN
CASE THAT IT IS REQUESTED IN YOUR
COUNTRY:
ECOLOGY AND RECYCLABILITY OF THE
PRODUCT
The materials of which the packaging of this
•
appliance consists are included in a collection,
classification and recycling system. Should you
wish to dispose of them, use the appropriate
public recycling bins for each type of material.
The product does not contain concentrations
•
of substances that could be considered harm-
ful to the environment.
• This symbol means that in case you wish to
dispose of the product once its wor-
king life has ended; take it to an au-
thorised waste agent for the selective
collection of Waste from Electric and
Electronic Equipment (WEEE).
This appliance complies with Directive 2014/35/
EU on Low Voltage, Directive 2014/30/EU
on Electromagnetic Compatibility, Directive
2011/65/EU on the restrictions of the use of
certain hazardous substances in electrical and
electronic equipment and Directive 2009/125/
EC on the ecodesign requirements for ener-
gy-related products.
EN