Whirlpool 4KWTW4605FW0 Guide D'utilisation Et D'entretien page 15

Troubleshooting
If you experience
Washer not performing as expected (cont.)
Not cleaning or
removing stains (cont.)
Incorrect dispenser
operation
Fabric damage
Odors
Lid Locked light is
ashing
EU representative: Whirlpool EMEA S.p.A., Via Carlo Pisacane n. 1, 20016 Pero (MI), Italy
Manufacturer: Whirlpool Corporation, 2000 N M 63, Benton Harbor, MI 49022 USA
For more information, visit us at www.applianceaccessories.com or contact the dealer from whom you purchased your washer or an
authorized service company.
Latin America Service
For other countries in Latin America, see our Warranty Card Latin America and visit our Whirlpool Latinoamerica website
First try the solutions suggested here to possibly avoid the cost of a service call.
Possible Causes
Using too much detergent.
Not using correct cycle for fabric type.
Not using dispensers.
Not washing like colors together.
Clogged dispenser.
Sharp items were in pockets during wash
cycle.
Strings and straps could have tangled.
Items may have been damaged before
washing.
Fabric damage can occur if load is tightly
packed.
Liquid chlorine bleach may have been
added incorrectly.
Garment care instructions may not have
been followed.
Monthly maintenance not done as
recommended.
Using too much detergent.
The lid is not closed.
A cycle was stopped or paused using
the Start/Stop/Pause/Unlock Lid button.
The suds from too much detergent can keep washer from
operating correctly. Always measure detergent and follow
manufacturer's directions based on load size and soil level.
Use a higher soil level cycle option and warmer wash
temperature to improve cleaning.
Use Deep Clean cycle for tough cleaning. See the "Cycle
Guide" to match your load with the best cycle.
Use dispensers to avoid chlorine bleach and fabric
softener staining.
Load dispensers before starting a cycle.
Do not add products directly onto load.
Wash like colors together and remove promptly after
the cycle is complete to avoid dye transfer.
Use only liquid chlorine bleach in the bleach dispenser.
Use only fabric softener in the fabric softener dispenser.
Empty pockets, zip zippers, and snap or hook fasteners
before washing to avoid snags and tears.
Tie all strings and straps before starting wash load.
Mend rips and broken threads in seams before washing.
Load garments in loose heaps evenly around the basket
wall. Load with dry items only.
Use cycle designed for the fabrics being washed.
Add only 1 or 2 additional garments after washer has
started.
Do not pour liquid chlorine bleach directly onto load.
Wipe up bleach spills.
Undiluted bleach will damage fabrics. Do not use more
than recommended by manufacturer.
Do not place load items on top of bleach dispenser when
loading and unloading washer.
Always read and follow garment manufacturer's care label
instructions. See the "Cycle Guide" to match your load
with the best cycle.
See "Washer Care" in "Washer Maintenance."
Unload washer as soon as cycle is complete.
Be sure to measure correctly. Always follow the
manufacturer's directions.
See "Washer Care" section.
Close the lid. The washer will not start or ll with the
lid open.
The washer may still be spinning. The lid will not unlock
until the basket has stopped spinning. This may take
several minutes if washing large loads or heavy fabrics.
www.whirlpool-latam.com.
Solution
15 15