Table des Matières
Publicité
General Instructions
Servicing the Rotoflex™:
Note: Refer to illustration on page 2 when following these directions for
servicing this unit.
Complete rebuild kit - Upper Arm Repair - 010188-45
1. Remove the two no.7 from no.28.
2. Hold top of no.19 while loosening no.8 with a wrench. Remove no.8.
3. Carefully lift no.21 from no.1.
4. Use retaining ring pliers to remove and discard no.26 from
no.23 and no.24 on no.21.
5. Slide the knuckle off
the shaft.(Shown right)
Remove no.25 from shaft
and discard. Clean and
inspect parts for damage.
If light scratches exist, use
a fine cloth to remove scratches,
if deep scoring exist, parts must be replaced.
6. Apply a thin coat of #111 grease to shaft. Assemble new
set of no.25 onto shaft and apply #111 grease to no.25.
7. Replace knuckles onto shaft and assemble two new
no.26. Set no.21 aside.
Riser Assembly Repair: Rotoflex™
1. Loosen no.36 of no.34 assembly.
2. Using a flat-blade
screwdriver at top of no.2,
unscrew and disassemble
no.2 from the base faucet.
3. Remove no.4 from no.3 and
discard. Loosen no.7 on no.6.
4. Carefully slide all components from no.2.
Upper End - Riser Assembly Repair
5. Remove no.15 and no.18 from upper end of no.1,
remove no.5, no.17 and no.16.
6. Clean and inspect no.2 and no.13 for damage and replace if necessary.
7. Slide no.5 onto no.14 end of no.2 and secure with no.15.
knuckle
26
25
(apply #111
shaft
grease)
(apply
#111
grease)
34
36
21, 23, 24
28
20
19
15
5
14
12
13
12
11
10
8
5
6
7
5
4
3
1, 2
18
17
16
Publicité
Table des Matières
