EINHELL GE-HM 18/38 Li Instructions D'origine page 29

11. Troubleshooting
Fault
The motor fails to
start
The motor perfor-
mance drops
Cutting is irregular
The mower spindle
does not turn
Important! For protection, the motor is equipped with a thermal switch which cuts out when
the motor is overloaded and switches on again automatically after a short cooling period.
Anl_GE_HM_18_38_Li_SPK9.indb 29 Anl_GE_HM_18_38_Li_SPK9.indb 29
GB
Possible causes
a) Motor terminals disconnected
b) The mower is standing in high
grass
c) The mower housing is clogged
d) Safety switch is not inserted
e) Battery is not correctly inserted
a) The grass is too high or too damp
b) The mower housing is clogged
c) The blade is severely worn
d) Battery performance decrea-
sing
a) The blade is worn
b) Wrong cutting height
c) The distance between the counter
blade and mower spindle is too
large
a) The counter blade and mower
spindle are touching each other
- 29 -
Remedies
a) Have repaired by the Customer
Service Center
b) Start in low grass or on an area that
has already been mowed; change
the cutting height if necessary
c) Clean the housing so that the blade
moves freely
d) Insert safety switch (see 6.)
e) Remove the battery and reinsert
(see 5.)
a) Correct the cutting height
b) Clean the housing
c) Replace the mower spindle
d) Check the battery performance
and charge the battery if necessary
(see 5.)
a) Resharpen the blades or replace
the mower spindle
b) Correct the cutting height
c) Adjust the distance (see 7.3)
a) Adjust the distance (see 7.3)
20.05.2019 10:06:40 20.05.2019 10:06:40