General Function - VAPamore MR-1000 Forza Mode D'emploi

FILLING & OPERATION
GO TO VAPAMORE.COM TO SEE THE MR-1000 FORZA INSTRUCTIONAL VIDEO

GENERAL FUNCTION:

!
or
!
internal components and can cause failure to internal parts and void the warranty.
!
without this screen in place. Failure to do so will void the warranty.
Fig.1
!
Do not ov
Cold water
tank fill cap
Fig.2
Use steam knob to
On / off
switch adjust steam output level
OFF
ST ATUS
ON
PRESSURE
Status light
the steamer is ready for use. (Initial start up from cold machine is aprox. 9 min) *The
status light will cycle red to green during use as the boiler maintains the temperature.
The Vapamore MR-1000 Forza has an industry high steam burst pressure of 90 psi. For
situations that need a short high pressure steam burst for cleaning, set the the steam
output to maximum pressure. For large cleaning areas that need a maintained steady
output knob from the full open position, counter clockwise approximately 1/2
revolution. The steam output knob can be turned down further for delicate jobs that
require very little pressure such as jewelry, fabrics, furniture, etc. (Fig.2)
. Using additives of any kind will void the warranty.
located on the top of the machine and using the
NOTE:
er
er
Do not ov
screen. (Fig.1)
Make sure the steam gun and hose is plugged into the
machine before startup. Plug the machine into a proper
wall outlet and swit
the pump is running hold the steam gun trigger down
_ for 15-20 seconds to release the air trapped in the boiler.
+
Once the boiler is full the pump will stop and the red
FILL
status light will light up showing the boiler is now
OUTPUT
heating the water. Once the boiler is at operating
Water fill light
temperature the status light turns to green indicating