Cleaning /Storage; Cleaning & Maintenance; Accessories - VAPamore MR-1000 Forza Mode D'emploi

GO TO VAPAMORE.COM TO SEE THE MR-1000 FORZA INSTRUCTIONAL VIDEO
CLEANING / MAINTENANCE
Always ensure before cleaning or maintaining the Vapamore MR-1000 Forza that it is
switched o and unplugged from the wall outlet.
Only clean the outer surface with a water moistened cloth. Do not use any cleaning
agents, abrasives or alcohol
Clean the cold water tank ll screen at least once a quarter (every 3 months) depending
on frequency of use to be sure there is no trapped debris in the screen. Remove the screen
by pulling up and out of the ll neck. Wash the screen under running water then replace.
Never ll the cold water tank without this screen in place. Failure to do
!
so can allow debris to enter the system and void the warranty.
detergents and wash cycle.
STORAGE / TRANSPORTING / SHIPPING
Fig.1
Cold water
drain
as you may damage the seal. The boiler drain is located on the underside in the center
of the steamer. The steamer MUST be 100% cooled down and have no pressure stored
in the tank to remove this cap. Remove the drain cap to drain the boiler then replace
and tighten the cap. Do not overtighten the cap as you may damage the seal. (Fig.1)
Never ship or transport the machine with water in the cold water tank.
!
The cold water tank MUST be completely emptied prior to shipping or transporting the
machine. Falure to do so can cause water to enter the machines internal parts and void
the warranty.

ACCESSORIES

Make sure all the o-rings are in place on the accessory tools and adapters. A silicon lube
can be used on these o-rings to help maintain a long use life.
Parts, extension tubes and accessories can be stored in the supplied accessory storage
bag and the storage basket located on the back of the steamer. The steam gun and hose
can remain plugged into the steamer and also be stored in the storage basket.
Replacement accessories and parts are available to order online at vapamore.com or by
calling Vapamore at 480-951-8900.

CLEANING /STORAGE

The cold water tank and main boiler tank should be
emptied before storing for any extended period of time
(30 days or more) or every 3 months of use to help remove
any debris that may have collected in the tanks. Make sure
the steamer is unplugged and completely cooled down
Boiler
before emptying the tanks. The cold water tank has a drain
drain
located on the underside closest to the right rear wheel.
Remove the drain cap to drain the cold water tank then
replace and tighten the cap. Do not overtighten the cap