Getting Started - VAPamore MR-1000 Forza Mode D'emploi

GO TO VAPAMORE.COM TO SEE THE MR-1000 FORZA INSTRUCTIONAL VIDEO
Once unpacked the items that need to be installed are the front & rear wheels, storage
basket with upright handles, front carry handle and cord hooks. All the necessary tools
and hardware are included to install these items.
Fig.1
Rear
Front Wheel x 4 Bolts
Wheel
Lock
Wheel Bolt
Nut
Fig.2
Fig.3
Cord
Cord
Hook
Hook
Front Carry Handle
FRONT CARRY HANDLE & CORD HOOKS
Attach the Front carry handle using the two supplies bolts and then tighten with
the supplied Allen tool. The cord hooks screw onto the studs located on the back of the
machine. Push inward to tighten the cord hooks. The cord hooks rotate by pulling
outward from the steamer then twisting to rotate. Use this rotate function to easily remove
the power cord and to position the hooks for cord storage. Use the Velcro cord strap to
secure the cord during transport. (Fig.3)
!
the steam gun trigger down for 15-20 seconds to release the air trapped in the boiler.
Vapamore
!

GETTING STARTED

FRONT & REAR WHEEL INSTALLATION
Install the front wheels using the supplied tool along
with the supplied wheel bolts, and washers. There
are 4 bolts and 4 washers per wheel. (Fig.1)
Install the rear wheels using the supplied tools along
with the supplied wheel bolt, and lock nut. The wheel
bolt is inserted into the wheel then inserted into the
steamer wheel mount. Once inserted, install the lock
nut then tighten. (Fig.1)
Upper Handle Bolt
BASKET & UPRIGHT HANDLES
The basket and handles are secured to the main steamer
Spacer Lower Bolt
using 6 supplied screws and 2 plastic spacers. (NOTE:
There are extra screws provided in the bag for backup).
Align the basket and handle screw hole locations and
insert the supplied screws loosely until all screws are in
place. The lower mount will also use the plastic spacer
between the handle and the steamer.
Once everything is in place secure all the screws with the
supplied Allen tool. (Fig.2)