VAPamore MR-1000 Forza Mode D'emploi page 5

ACCESSORIES AND TOOLS
GO TO VAPAMORE.COM TO SEE THE MR-1000 FORZA INSTRUCTIONAL VIDEO
!
Fig.1
Fig.2
Accessories twist lock onto
the accessory tool adapter
Fig.3
Accessory tool adapter
attaches to the steam
gun or extension tubes.
Fig.4
Use large elbow adapter for
floor heads and triangle brush
Fig.5
Use with steam gun
or extension tubes
Fig.6
Extension tubes
lock and release
Never operate machine without water in the main tank.
The MR-1000 Forza has an accessory and
Water bottle
tool basket. Once all the accessories and tools have
and holder
been unpacked use the accessory storage bag and
basket to carry all the accessories and tools.
Accessory
storage
basket The MR-1000 Forza includes a water bottle holder
that can be used for the included water bottle or
most any other drink bottle or cup. The water bottle
holder attaches to the basket using the supplied
mounting screws.
The accessory tool adaptor (#4 on parts overview
page) is required when using the jet nozzle
attachment, detail scraper, and all round detail
brushes (#5-12 on parts overview page). Align the
accessory with the arrow on the accessory tool
adapter and twist to lock into place. The accessory tool
adapter can be used directly on the steam gun or can
be used with the extension tubes. (Fig.2 and 3)
The large elbow adaptor (#14 on parts overview
page) is required when using the floor heads or
triangle corner brush (#15-17 on parts overview page)
With the large elbow adapter facing down, insert
into the floor heads or triangle brush until completely
inserted then rotate up. The adapter will only insert
when facing down and then locks into position and
allows the adapter to rotate when in use. The large
elbow adapter can be used directly on the steam
gun or can be used with the extension tubes.
The smooth surface squeegee, detail jet tool and the
bed bug / fabric tool (20-22 on parts overview page)
can be connected directly to the steam gun or the
extension tubes.
STEAM GUN / EXTENSION TUBES
The steam gun connects to the steam socket located
on the front panel of the machine. Flip the dust cover
open and push the hose connector firmly into the
socket until both tabs click into place. Remove the
steam hose by pressing in both release tabs while
pulling out.
The steam gun has a trigger (ON) lock located just
behind the trigger. This lock can be used for
continuous steam without having to hold the trigger.
To set the lock, push down the trigger, then while the
Trigger lock
trigger is down slide the lock to hold the trigger.
Extension tubes can be used for floors or difficult to
reach areas. The extension tubes push and lock into
place on the steam gun. (Fig.6)
(Fig.1)
(Fig.4)