babymoov Transat Bubble Notice D'utilisation page 9

USE AND SPECIFICATIONS OF BABY ROCKER
A. Unfolding the baby rocker
Unfold the side bars, then insert the front part into the bar provided for this purpose until you hear a click (Figures
1, 2 3, 4 and 5).
B. Reclining the back
Lift up the two recline buttons (b) together to recline the back (Figure 6). Lower the two recline buttons (b) together
to lock the back (Figure 7).
C. Recliner seat or rocker position
Recliner seat position (Figure 8)
Lower the non-slip legs (a) so as they raise the recliner seat slightly.
Rocker position (Figure 9)
Leave the non-slip legs (a) folded to allow for rocking.
D. Fitting the 3-point safety harness (e)
Slide the belt into the harness. Adjust the position of the belt by sliding it (Figures 10, 11 and 12).
E. Using the removable cushioned liner (d) (Figure 13)
F. Using the removable toy bar (f)
Fix the toy bar (f) to the side bars of the baby rocker (Figures 14 and 15).
G. Using the canopy (i) (complete model)
Insert the ends of the canopy (i) into the end pieces provided for this purpose on either side of the baby rocker
(Figures 16 and 17).
Adjust the canopy (i) to your liking (Figure 18).
H. Folding up the baby rocker
Make sure that the seat recline is locked and that the toy bar (f) is lowered (Figure 19).
To fold up the non-slip legs (a), turn the baby rocker so that the footrest (g) is upwards. Hold one of the two non-
slip legs (a) in one hand and press the recline button (b) of the leg with the other (Figure 20). Push the non-slip
leg (a) downwards by swivelling it slightly. When you hear a click, swivel the leg inwards (Figure 21). Do the
same with the other leg (Figures 22, 23 – simple model and 24 – complete model).
I. Carrying the baby rocker
Hold the baby rocker by the two carry handles (h) (Figure 25).
CARE AND WASHING INSTRUCTIONS
• Check the baby rocker often for loose screws, worn parts, torn fabrics, or stitching that has come undone.
• Change or repair parts if required. Only use spare parts recommended by Babymoov.
• Excessive exposure to the sun or heat may cause fading of colours or warping of parts.
• To clean the frame of the baby rocker, only use household soap or a detergent and warm water. Never use bleach.
• The removable protective cover and the removable cushioned liner are surface washable. Use a damp cloth
and soap.
rn j
• 100 % polyester.
9
BUBBLE BABY ROCKER • Instruction Manual