Qlima A 25 Manuel D'utilisation page 40

troubLeshooting
Check the following before contacting technical support:
Problem
Light 3 on the display is
blinking
The device does not
work
The remote control is
not working.
The device does not
remove odours and/or
dust.
The Auto mode doesn't
work.
No / insufficient air circu-
lation.
4
40 40
Cause
Dirty filter
The front panel has not been
replaced correctly.
The power cord is not connected. Insert the plug into the socket.
The power cord is not connected
properly.
The fuse of the unit is defective.
The batteries in the remote con-
trol are dead.
The filter package has not been
inserted correctly.
The filter package is dirty.
The sensor is dirty.
The air flow is blocked.
solution
Replace the filter package and
reset the filter alarm by pressing
Button 2 on the remote control
for 3 seconds
Remove the front panel and put
it back again. Make sure that the
top of the panel is placed cor-
rectly.
Insert the plug into the socket
correctly.
Have the fuse replaced by a
recognised Qlima dealer.
Replace the batteries.
Insert the filter package cor-
rectly.
Replace the filter package.
Run the air cleaner ventilator at
its highest setting.
Remove the blockage.
Replace the filters.