Domair SANTORIN Manuel D'utilisation page 42

The air conditioner will automatically
stop when the room temperature is be-
low the selected temperature.
2.2 Dehumidification mode (DRY)
- connect a drainage hose (not sup-
plied) so that water is discharged conti-
nuously.
- press the MODE key to select the
dehumidification mode: the correspon-
ding LED lights up.
NOTE: The dehumidifier runs conti-
nuously, the fan speed and temperature
cannot be changed (only «LOW» speed
is available).
2.3 Ventilation mode (FAN)
- press the MODE key to select the ven-
tilation mode: the corresponding LED
lights up.
- Press the SPEED key successively to
select the (LOW) or (HIGH) fan speed:
the corresponding LED lights up.
3. SLEEP MODE KEY
IMPORTANT: This mode can only be
activated from the remote control, and
only in the cooling mode.
- from the cooling mode, if the SLEEP
mode is activated, the selected tem-
perature increases by 1°C after 1 hour
of operation, then by an additional 1°C
after 2 hours. It will then remain at this
setting.
- all the LEDs switch off gradually, and
the fan automatically switches from
high speed to low speed.
NOTE: In dehumidification and ventila-
tion mode, the sleep mode cannot be
selected.
- In sleep mode, the fan speed remains
at «Low» speed, and cannot be chan-
Rev 1_10 12 19
ged.
4. SPEED KEY
- Press the SPEED key successively to
select the (LOW) or (HIGH) fan speed:
the corresponding LED lights up.
NOTE: The fan speed cannot be chan-
ged when the dehumidification (DRY) or
sleep (
5. TIMER KEY
This key is used to turn the device on or
off from the programmable timer.
NOTE: the time that can be program-
med is from 1 to 24 hours.
START TIMER: The start timer key is
used to turn the device on at the end of
the programmed time.
1. In standby mode, press the «TIMER»
key to set the required time. The
TIMER indicator will light up and the
display will show 1 hour.
2. Repeatedly press the «INCREASE»
or «DECREASE» keys to display the
desired time.
3. If the «TIMER» key is not pressed for
a few seconds, the time display will
disappear and be replaced by the dis-
play of the ambient temperature. The
timer is then activated.
4. At the end of the time set, the device
will turn on automatically.
SLEEP TIMER: the sleep timer key is
used to put the device in standby at the
end of the programmed time.
1. While the air conditioning is in opera-
tion, press the «TIMER» key to deter-
mine the required time of operation.
The TIMER indicator will light up and
the display will show 1 hour.
Fabriqué en Chine
) modes are selected.
Page 42