Outlet Pipe - Domair SANTORIN Manuel D'utilisation

INSTALLATION OF THE OUTLET PIPE
1. If it is not already assembled, fit the
connector (2) onto the outlet pipe (1).
2. Fit the other end of the pipe into the
adapter (3).
3. Fit the connection (2) of
the outlet pipe (1) to the
hot air outlet of the air
conditioner.
4. Install the adapter (3) into the win-
dow kit, then the window kit into the
rail of your sliding window. When the
window is closed, it must be as tight
as possible. If necessary, shutters
should be added in order to avoid
energy loss (consult dealer if neces-
sary)
Rev 1_10 12 19
5. Adjust the length of the outlet pipe:
- The outlet pipe must be held paral-
lel and must not be bent or directed
downwards: the air must be able to
flow freely through the pipe.
- Do not extend the outlet pipe to a
length of more than 400 mm. Even if
the pipe supplied is extendable, do not
attempt to lengthen it excessively. Do
not replace it with a longer pipe: the
length between the device and the
extractor must be as short as possible.
- This device is suitable for a surface
area of approximately 30 m².
- Make sure that the hot air outlet pipe
adapter is properly set up according to
your type of window. Do not twist the
pipe excessively.
Fabriqué en Chine Page 40