GE Profile 22 Manuel D'utilisation Et D'installation page 31

INSTALLING THE REFRIGERATOR
PUT THE REFRIGERATOR IN PLACE
4
LEVEL THE REFRIGERATOR
5
The refrigerator can be leveled by adjusting
the rollers located near the bottom hinges.
Rollers have three purposes:
• Rollers adjust so the door closes easily when
opened about halfway. (Raise the front about
•
• Rollers allow you to move the refrigerator
away from the wall for cleaning.
To adjust the rollers on 23' (33" wide), 25', 26',
27' and 29' models:
• Turn the roller
adjusting screws
clockwise to raise
the refrigerator,
counterclockwise
to lower it. Use
a
or wrench, or an
adjustable wrench.
Installation Instructions
Raise
Rollers
Roller adjusting screw
(CONT.)
LEVEL THE REFRIGERATOR (cont.)
5
To adjust
the rollers on 23
models:
CustomStyle
™
Turn the front roller
adjusting screws
clockwise to raise
the refrigerator,
counterclockwise
to lower
wrench with extension, or an adjustable wrench.
These models also have rear adjustable
rollers so you can align the refrigerator with
with extension to turn the screws for the rear
clockwise to raise the refrigerator,
counterclockwise to lower it.
LEVEL THE DOORS
6
Adjust the refrigerator door to make the doors
even at the top.
To align:
A
screw to the right to raise the door, to the left
to lower it.
NOTE:
A nylon plug, imbedded in the threads
of the pin, prevents the pin from turning
unless a wrench is used.
After one or two turns of the wrench, open
B
and close the refrigerator door and check
the alignment at the top of the doors.
31
25
'/ '
Roller adjusting screws
Doors should be even at top
Raise