Jtable Of Faults - Mussana PONY Notice D'utilisation

J
TABLE OF FAULTS
Please note:
Opening the machine's cover is only permitted after agreement in advance with the
proper specialist dealer. Improper opening can lead to the damage of the electronic
components inside the machine.
Please Note:
Fault
1. The cooling machine ist not starting
up on the fi rst use.
2. The pump is not sucking up any
water or cream
3. Cream is turning to butter in the
whipping system
4. The cream is too runny.
5. During the cleaning process, the red
control diode illuminates.
6. Duriing normal operation, the red
cooling diode illuminates.
7. Failure in functioning of one or
several buttons on the operating
panel.
Before opening the machine's cover, always pull out the mains
plug!
Advice
Leave the machine about 20 mins without
mains connection so that pressure can be
reduced. Then re-connect to mains.
The pump is dry. Pour a little liquid trough
the opening of the air regulating valve, after
which the pump will work independently.
The cream is too warm and/or the air
regulating valve is on too thigh a setting.
Dismantie and clean the whipping system
Re-assemble all parts and make an
adjusment to the air setting. Pre-cool the
cream well.
Turn up the air regulating valve if the air
regulating valve is blocked, dismantie into 3
parts and clean.
The temperature reader reacts when hot
water is used. After cleaning, the grenn
control diode will light up again after a short
pause.
No self-help is possible. Please contact your
specialist dealer.
No self-help is possible. Please contact your
specialist dealer.
8