Dbringing Into Service - Mussana PONY Notice D'utilisation

D
BRINGING INTO SERVICE
1. Insert the plug into the suitable contact protected mains point. The refrigerator and
ventilator start up automatically. The red control light illuminates fi rst of all on the
operating panel.
2. Before using for the fi rst time, the machine should be cleaned, following our
cleaning instructions in point (H).
3. After about 20 minutes, the cream whipping machine has cooled down. This will
be indicated by the green light diode (operating situation).
Please Note:
4. Fill the required amount of pre-cooled cream into the cream container.
5. Place the air regulating valve to position 2 - 3 and press the manual button until
the cream comes out of the decorating nozzle. If the whipped cream does not
meet your expectations, please read further under section E (explanation of the air
regulating valve).
Should the pump not immediately absorb the cleaning liquid or the cream, unscrew
and remove the complete air regulating valve and apply drops of water directly into the
pump, after which the pump can absorb again.
3
Never fi ll the cream directly into the stainless steel inner
container!