Removing Tipone Repeat Dispenser Tips; Safety Precautions And Operational Limitations - Star Lab RepeatOne Mode D'emploi

3.4. Removing TipOne Repeat Dispenser Tips
®
• Hold RepeatOne over a beaker.
®
• Slowly depress the filling lever down to the stop.
This will completely empty the TipOne
Dispenser Tip.
• Raise the locking clamp upward.
• Remove the TipOne ® Repeat Dispenser Tip.
Note: When using the 25 ml or 50 ml TipOne
Dispenser Tips, the reusable adapter is removed by turning
it counter clockwise.
(Fig. 8)
® Repeat
® Repeat
Fig. 8

4. Safety Precautions and Operational Limitations

When removing TipOne Repeat Dispenser Tips, please
®
note the following:
• Do not touch the tip end, especially when using
hazardous reagents!
• Empty the dispenser tips into a proper discard receptacle
to avoid splashing and aerosols.
• Treat any retained fluid as a bio-hazard. Do not allow the
fluid to come into contact with laboratory personnel.
• If dispensing a liquid with a surface tension significantly
different from water, inaccuracies or leaking can occur.
• The RepeatOne with an attached, partially filled
®
TipOne Repeat Dispenser Tip should be stored in a
®
stand to prevent air entering the dispenser tip.
9
RepeatOne · User Manual ·