Side Handle; Grinding And Cut-Off Wheels - ITC IPT-450 Guide D'utilisation

ASSEMBLY
GUARD
Your grinder comes with an adjustable wheel guard. This is to allow you to
grind at various angles and still be protected to some extent from flying
residue or debris.
● If the guard needs to be installed, or if you wish to rotate the guard to
provide more protection at the angle you plan to use the grinder:
!
WARNING - Be sure the tool is switched off and unplugged.
1. Loosen the clamping screw (a, fig.II) on the collar.
2. Locate the guard collar onto the tool or rotate the guard to give you
protection and expose the disc on the appropriate side.
3. Tighten the screw to clamp the guard in place.
!
CAUTION - Do not use this tool with the guard removed.

SIDE HANDLE

The auxiliary side handle (G, fig.I) for your grinder may be fitted to either
the left or right side of the unit. Select the position which provides the
most comfortable and safe use.
!
WARNING - Be sure the tool is switched off and unplugged.
1. Screw the handle firmly into the threaded hole on the left side of the
metal gear head for right-handed operation.
2. Screw the handle firmly into the threaded hole on the right side of the
metal gear head for left-handed operation.

GRINDING AND CUT-OFF WHEELS

● Your grinder is designed to accept only 4-1/2" or 115 mm diameter
abrasive discs with a 7/8" bore.
● 12,000 RPM is the operating speed of your grinder.
● Check also for any damage to an abrasive disc before you install
it. Any disc that shows a crack, has been dropped, or subjected
to other damage due to temperature extremes or solvents should
be discarded. A damaged disc can fly apart in use and may cause
serious injury to the operator or bystanders.
5