ROTOR GK900 Mode D'emploi page 17

CH-3661 Uetendorf
Mix
ON
OFF
Never use the blender without having the lid properly in place.
Hold the lid by hand!
Danger of scalding from hot drinks!
To avoid heavy injuries or damages of the appliance, it is for-
bidden, while mixing to reach into the container with hands or
with a hard solid object. This is although valid by a standing
still motor and assembled container, in case of unintentional
switching. Do not reach into the container with a hard solid
object by opening the lid lock.
The blender should never run without container.
Never put a cutter assembly on the motor base without
the container!
Only fit or remove container when motor is stationary.
Do not touch, nor with any other object, the rotating coupling
piece on top of the motorbase.
Instruction Manual
Rotor Gastronom GK900
- Insert the container on the motor base, taking care to keep it
vertical.
- Add ingredients to be mixed.
- Place the lid in such a way, that the hole in the tab at the lid
sticks over the end of the rod, that the lid is firmly closed.
- Switch on motor and vary the speed according to the ingre-
dients being mixed, turn the speed control knob clockwise
until the desired speed is reached. The maximum speed is
reached at position 8.
- Turn off: Turn the speed control knob counter clockwise
to "0", after remove the lid or the container.
Particularly in the case of thick, viscous materials, the highest
possible speed should be selected so that the motor is not
heated up unnecessarily.
Liquids and fine grained materials can be added through
the filler opening in the lid of the container during operation
(Remove the lid lock).
The motor only runs if the lid is in position!
By switching on and operating at high speed, it is recommen-
ded that the bowl should be held (lay hand on the lid).
© Rotor Lips AG
15