Télécharger Imprimer la page

Husqvarna 333R Mark II Manuel D'utilisation page 13

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 104
Fuel
To use fuel
CAUTION: This product has a two-cycle
engine. Use a mixture of gasoline and two-
cycle engine oil. Make sure to use the
correct quantity of oil in the mixture.
Incorrect ratio of gasoline and oil can cause
damage to the engine.
Gasoline
CAUTION: Do not use gasoline with an
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
CAUTION: Do not use gasoline with more
than 10% ethanol concentration (E10). This
can cause damage to the product.
CAUTION: Do not use leaded gasoline. This
can cause damage to the product.
Always use new unleaded gasoline with a minimum
octane number of 90 RON (87 AKI) and with less
than 10% ethanol concentration (E10).
Use gasoline with a higher octane number if you
frequently use the product at continuously high
engine speed.
Always use a good quality unleaded gasoline/oil
mixture.
Two-cycle engine oil
Use only the two-cycle engine oil of high quality,
especially HUSQVARNA two-cycle oil. Use only the
oil of an air cooled engine.
Mixture ratio 50:1 (2%).
Oil of low quality and high oil/fuel ratio can decrease
the lifetime of catalytic converters.
Speak to your dealer when you select an oil.
If Husqvarna two-stroke oil is not available, you can
use another two-stroke oil of good quality that is
intended for air cooled engines. Contact your dealer
when you select oil.
Do not use the two-stroke oil for water-cooled
outboard engines. The two-stroke oil is sometimes
referred to as outboard oil.
Gasoline, liter
5
10
15
1542 - 002 - 17.07.2020
Oil, liter
2%(50:1)
0,1
0,2
0,3
Gasoline, liter
20
To make the fuel mixture
Note: Always use a clean fuel container when you mix
the fuel.
Note: Do not make more than 30 days quantity of fuel
mixture.
1. Add half of the gasoline quantity.
2. Add the full quantity of oil.
3. Shake the fuel mixture to mix the contents.
4. Add the remaining gasoline quantity.
5. Shake the fuel mixture to mix the contents.
6. Fill the fuel tank.
To add fuel
WARNING: Do not smoke or put hot objects
near fuel. Before you add fuel, stop the
engine and let it cool for minutes.
WARNING: When you add fuel, open the
fuel tank cap slowly to release unwanted
pressure.
WARNING: After you add fuel, tighten the
fuel tank cap carefully. Move the machine
away from the refuelling area and the power
before you start the engine.
Always use a fuel container with an anti-spill valve.
Make sure that the area near the fuel tank cap is
clean. Contamination in the tank can cause
operating problems.
Shake the fuel container before you add the fuel
mixture to the fuel tank.
To start and stop
To examine before start
1. Examine the product for missing, damaged, loose or
worn parts.
2. Examine the nuts, screws and bolts.
3. Examine the trimmer head or the blade.
4. Examine the locknut. Make sure that the locknut has
a minimum locking force of 1.5 Nm (1,1 ft lb). Torque
the locknut to 35-50 Nm (26-36 ft lb).
5. Examine the air filter.
6. Examine the throttle trigger lockout and the throttle
control.
Oil, liter
0,4
13

Publicité

loading