General - Victron energy Solar Module Mode D'emploi

2. General

Installing solar photovoltaic systems may require specialized skills and knowledge. Installation should be performed only by
qualified persons.
Each module comes with a permanently attached junction. We can provide customers with fitted cables for ease of installation if
desired.
Installers should assume the risk of all injury that might occur during installation, including, without limitation, the risk of electric
shock.
One individual module may generate DC voltages greater than 30 volts when exposed to direct sunlight. Contact with a DC voltage
of 30V or more is potentially hazardous.
Do not disconnect under load.
Photovoltaic solar modules convert light energy to direct-current electrical energy. They are designed for outdoor use. Modules may
be ground mounted, mounted on roof tops, vehicles or boats. Proper design of support structures is responsibility of the system
designers and installers. Use of mounting holes is suggested in a following paragraph.
Do not attempt to disassemble the modules, and do not remove any attached nameplates or components from the modules.
Do not apply paint or adhesive to module top surface.
Do not use mirrors or other magnifiers to artificially concentrate sunlight on the modules. Do not expose back-sheet foils directly to
sunlight.
When installing the system, abide with all local, regional and national statutory regulations. Obtain a building permit where necessary.
3