General Installation - Victron energy Solar Module Mode D'emploi

4.6 General installation

Module mounting must use the pre-drilled mounting holes in the frame.
The most common mounting is achieved by mounting the module using the four symmetry points close to the inner side on module
frames.
If excessive wind or snow loads are expected, all eight mounting holes must be used
Do not lift the module by grasping the module's junction box or electrical leads.
Do not stand or step on module.
Do not drop module or allow objects to fall on module.
To avoid glass breakage, do not place any heavy objects on the module.
Do not set the module down hard on any surface.
Inappropriate transport and installation may break module.
7