Safety Instructions - Dreve Labormat SD Mode D'emploi

Labormat SD, TH

5. Safety instructions

Attention! Please read these instructions carefully before connecting and commis-
sioning the device. The operational safety and function of the device can only be guar-
anteed if both the general statutory safety and accident prevention guidelines and the
safety information in the operating instructions are observed.
1. The device may only be used in
accordance with these operating
instructions. We do not accept any lia-
bility for damage incurred as a result
of non-designated use or incorrect
operation.
2. The voltage indicated on the rating
plate must comply with the voltage sup-
plied by the power source.
3. The device may only be connected to
a power outlet with a protective con-
ductor. Never touch the mains plug with
wet hands.
4. The power supply for Labormat
devices should only be established by
a separately-fused power supply line.
5. The device must be set up on a stable
and level surface.
6. The heating may only be switched on
and operated when the device is filled
with a sufficient volume of water.
7. The condition and operational safety
of the device must always be examined
before use. If the device is not in perfect
condition, it may no longer be used and
must be marked accordingly.
44
8. Do not lock the device operating ele-
ments into place.
9. The timer operating elements should
not be actively turned anticlockwise.
This overstresses the internal spring
causing the timer to wear faster.
10. When working for longer periods of
time at the maximum operating temper-
ature, the Labormat lid and interior parts
of the housing can heat up to 80 °C; do
not therefore touch them even briefly
except using the designated handles.
11. Do not lean over the device when
opening the lid. Evaporation by hot
steam represents a risk of scalding.
12. Signs and labels must be kept
clearly legible and may not be removed.
13. The device should only be cleaned
and maintained or parts removed when
the unit has cooled down. The mains
plug must be pulled.
14. Waste water should only be dis-
charged into the sewerage system at
temperatures below 75 °C. Higher tem-
peratures can damage the waste water
lines over the long term.
15. The device may only be opened and As we constantly strive to develop our
repaired by authorised specialists. products, we reserve the right to make
technical modifications.
16. Only accessories and spare parts
approved by the manufacturer may be
used. We do not accept any liability for
damage incurred by using parts which
have not been approved.
45