Setting The Depth Stop - TOM TPC-16AL Manuel D'utilisation

Setting the depth stop:

use the depth stop to drill several holes of the same depth. lower the shaft with the drill to the required depth.
Set the depth stop setting nut (E, fig. 1) on the locking jaws. When you turn the wheel, the bit cannot be lowered below that
depth.
table tilt:
never carry out this setting when the machine is operating. loosen screw c to tilt the table.
iMPOrTanT!
loosen screw c only slightly; otherwise, the table and the extensions may fall off.
Set the required table angle.
tighten the screw.
If needed, loosen wing screws b to pull out the side extensions A.
C
Laser guide:
the laser is started up by means of a switch located on the front of the machine.
the laser A is used for centring the workpiece on the table. For best results, the laser must be adjusted by tilting it forwards or
backwards so that the cross formed by the beam indicates the centre of the table.
the laser guide emits harmful radiation when it is operating. Keep your eyes safe from direct exposure.
warning: max. power < 1 mw, wavelength: 630 - 670 mm, dInEn6085-1: 1997, laser radiation: do not stare at the beam, class II
laser.
18
disconnect the machine from the mains before starting
any maintenance, setting or cleaning work!
All the connections and repairs of the electrical system
A may be carried out by a qualified electrician only.
Immediately replace damaged or worn safety devices.
cleaning: clean the machine regularly.
lubrication: regularly apply a bit of grease to:
•The drive shaft.
•The gears of the drilling spindle.
B