TOM TPC-16AL Manuel D'utilisation page 16

assEMBLY
iMPOrTanT!
Unpack the drill press and make sure that it is not damaged.
If any part appears damaged, take the machine back to your point of sale, and do not attempt to assemble it.
Column assembly
Secure the column using three screws (plain washers + lock washers) and tighten firmly. Assemble the table D of the drill press on the
column, while positioning the rack in the collar.
Position the rack collar
Assemble the drill press head on the column.
Position the drill press head parallel to the base.
Fasten the headless screws on the right-hand side of the drill press head using the Allen key supplied. Screw the three balls on the
chuck lowering wheel.
Assembling the chuck guard visor
unscrew and remove the central screw of the guard
Fit the guard visor.
Put back the central screw with its nut and tighten it.
Fasten the two screws to the right and left of the visor. these two screws are placed on the ring.
Assembling the chuck
thoroughly clean the morse taper of the drill press and the female taper of the chuck.
Snap the chuck into the taper.
Take a block of wood, place it on the table, move in the chuck jaws and then turn the wheel firmly so as to strike the chuck on the
wooden block.
electrical connections
the connections and the extension cords used must comply with the instructions. the voltage and frequency must be as stated on the
machine.
the rating of the mains fuse must be 10A.
use H07 Rn-F type cables for the connections.
All the connections and repairs of the electrical system must only be carried out by a qualified electrician .
Starting up
this machine must be connected to the earth.
the drill press motor is started up by means of a switch located on the left-hand side of the drill press.
16
B
D
A
C