General Guidelines - HQ Power SOUND MACH I Mode D'emploi

3. General Guidelines

• The VDSSM1 should only be used indoors with an alternating current of max. 230VAC / 50Hz.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme heat (see "Technical Specifications"), dust and
moisture.
• Install the device in a well-ventilated area. Keep a minimum distance of 0.3m around the device.
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
4. Fuse Installation
• Only fit or replace a fuse when the device is unplugged from the mains.
• If the lamp burns out, chances are you will need to replace the fuse as well.
• Replace a blown fuse with a fuse of the same type and rating (15A / 250VAC 5 x 20mm, order code: FF15N):
1. Unscrew the fuse holder on the rear panel with an appropriate screwdriver.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder and fasten it with the screwdriver.
5. Description
Subwoofer rear panel
1. right signal input
2. through for right
3. right channel volume control
4. left channel volume control
5. left signal input
6. through for left
7. bass volume control
8. ground-lift switch
9. hidden volume limit control for right channel
10. hidden volume limit control for left channel
11. crossover talk
12. left speaker output
13. right speaker output
14. power input
15. fuse (15A)
16. power switch
Satellite rear panel
1. signal input
2. +/- 3dB switch
3. through for signal
VDSSM1 2 VELLEMAN