To Operate The User Interface; Before Operation; To Fix The User Interface To The Wall; To Insert The Batteries - Daikin Siesta ATXP20M5V1B Mode D'emploi

3 Before operation

Icon
Airflow rate = Indoor unit quiet
Airflow rate = High
Airflow rate = Medium high
Airflow rate = Medium
Airflow rate = Medium low
Airflow rate = Low
Comfort operation is active
Automatic vertical swing is active
Automatic horizontal swing is active
ON timer is active
OFF timer is active
2.2.3

To operate the user interface

a Signal receiver
1 Aim the signal transmitter at the signal receiver on the indoor
unit (maximum distance for communication is 7 m).
Result: When the indoor unit receives a signal from the user
interface, you will hear a sound:
Sound
Beep-beep
Beep
Long beep
Operation manual
4
Description
a
Description
Operation starts.
Setting changes.
Operation stops.
3 Before operation
3.1

To fix the user interface to the wall

2×
a b c
a User interface
b Screws (field supply)
c User interface holder
1 Choose a place where the signals reach the unit.
2 Attach the holder with screws to the wall or a similar location.
3 Hang the user interface on the user interface holder.
3.2

To insert the batteries

The batteries will last for about 1 year.
1 Remove the back cover.
2 Insert both batteries at once.
3 Put the cover back.
1 3
2
AAA.LR03
3.3 To switch between Fahrenheit and
Celsius
Prerequisite: Change this setting only when the temperature is
displayed.
1 Press and simultaneously for about 5 seconds.
Result: The setting changes.
3.4

To turn on the power supply

1 Turn the circuit breaker on.
Result: The flap of the indoor unit will open and close to set the
reference position.
ATXP20~35M5V1B
R32 split series
3P520336-7B – 2018.12