VONROC GT501DC Traduction De La Notice Originale page 12

EN
Tilting the trimmer head (Fig. H)
Please keep power switched off and
disconnect the battery.
• Press the knob (20) of the trimmer head to tilt
the head in the desired position.
• When knob is released, the head will click and
lock in the chosen position.
Turning the trimmer head (Fig. I)
• Press the ring (21) down towards the trimmer
head to turn the head in the desired position.
• When the ring is released, the head will click
and lock in the chosen position.
Adjusting the pole height (Fig. J)
• To adjust the height of the machine, loosen the
lower adjustment ring (22).
• Carefully push the lower shaft (24) from the
upper shaft (23) down or upwards.
• Fasten the lower adjustment ring (22) to secure
the height of the machine.
Using your grass trimmer
Before use, always visually inspect the
machine and its parts are correctly
mounted, not worn out or damaged.
• For your own safety and for best results read
the following user advice and do not use this
product for anything other than its intended
purpose.
• This grass trimmer is made for cutting grass.
All other use that is not specifically allowed in
this manual may lead to damage to the grass
trimmer or injury to the user.
Safety features
• The protection guard has a knife for cutting
the wire to the correct length. Do not touch the
knife to reduce the chance of injury to the user.
• The on/off switch (6) and safety switch (7)
must be operated together to start the motor.
If pressure on one of two switches is released,
the tool is designed to stop rapidly.
Switching On and Off
• To switch the trimmer on, press the safety
switch (7) and the start on/off switch (6) at the
same time.
• To switch off, release one or both switches.
12
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that the
ventilation openings are free of dust and dirt. Re-
move very persistent dirt using a soft cloth moiste-
ned with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of defects
in both materials and workmanship for the period
lawfully stipulated starting from the date of original
purchase. Should the product develop any failure
during this period due to defective material and/or
workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by compa-
ny either expressed or implied. There are no other
warranties expressed or implied which extend
WWW.VONROC.COM